Layer3 message to check 5G NR Throughput during UE session

5G NR
,
1

Hi Experts.
Which Layer3 message can I check the NR Throughput during UE session?
If possible, could you share any example?

2

Hi @Cesar_Nunes there is no way, any throughput check in RRC layer, the throughput only could be measured at PDCP, RLC, MAC and Physical layer…RRC (Layer3) only used for carrying signaling.

1 Like
3

Not sure if it helps, but a few suggestions for it, depending on what you are trying to look at:

  1. MDT
  2. NW traces, especially for Hauwei, have a lot of information, including throughput.
  3. Probes
4

Hi Experts,
I have some questions regarding t5G Throughput.

  1. Where can I get the UE DL actual throughput value? on PDSCH thp or PDCP thp?
  2. Normally cell thp is higher than UE thp but what ratio should I expect, is it normal DL Cell thp:150 Mbps vs DL UE Thrp: 18 Mbps
    Thanks in advance.